KRESS 800 FDF Mode D'emploi page 23

Tools and accessories
Routing S6 Biscuit Joint Connections
For joints with plate thicknesses in excess of 30
mm, such as door frames, stairs or bed frames,
the use of S6 biscuits is recommended.
Both grooves are to be routed 10 mm apart.
Routing Thin/Narrow Workpieces
For narrow workpieces, use the stop 6 if possible
and pay attention that the marks 7, where the rout-
er blade engages laterally, are within the work-
piece.
NOTE:
For frame joints or thin workpieces, the use of H9
biscuits is recommended. A special routing tool is
required for this.
5. Tools and accessories
Always wear a dust protection mask when
working with the power tool.
Chip/Sawdust Extraction
Dust extraction prevents large accumulations of
dust, high concentrations of dust in the ambient air
and facilitates disposal.
For long periods of working with wood or for com-
mercial use on materials that produce dust that is
detrimental to health, the machine is to be con-
nected to a suitable external dust extraction de-
vice.
For extraction of dusts that are particularly harmful
to one's health, carcinogenic or dry, use a special
vacuum cleaner.
Adapter for Connection with a Vacuum
Cleaner
24
25
26
The adapter 25 enables the extraction of chips
and sawdust using a commercially available vac-
uum cleaner.
If required, a rubber reducer must be used to re-
duce the connection diameter to fit the diameter of
the vacuum cleaner hose.
The vacuum cleaner must be suitable for the ma-
terial being worked.
Mounting the Dust Collector
For small routing applications, the supplied dust
collector 24 can be used for dust extraction.
Attach the dust collector to the stop on the adapter
25.
NOTE:
To maintain optimum dust collection, empty the
dust bag 22 in good time.
To empty the dust collector, open the zipper and
carefully strike or tap out the dust/debris.
Chip Ejection
With the ejector adapter 15, the direction of chip
ejection is deflected to the side, keeping the work
area free of chips and sawdust. Insert the ejector
adapter into the ejector opening until it latches.
6. Maintenance and Service
Maintenance and Cleaning
Before carrying out any work on the
machine, pull the main plug.
Always keep the machine and ventilation
slots clean.
Wipe off the accessible plastic parts regularly
with a cloth without cleaning agent.
Clean and grease the column guides 5 as re-
quired. Only use non-gummy oil (e.g. sewing
machine oil).
Replacing brushes
Worn carbon brushes should be replaced by an
authorised customer service organisation.
English 23
EN
FDF-EN / 0802