KRESS 800 FDF Mode D'emploi page 19

Operation
Noise and Vibration Information
Noise levels
Measured values
EN 60 745.
Typically the A-weighted noise levels of the ma-
chine are:
sound pressure level (L
sound power level (L
wA
Measurement uncertainty K=3 dB
The noise level can exceed 85 dB(A)
during operation.
Wear ear protection!
Vibration
The estimated acceleration is typically smaller
than 2.5 m/s².
Triaxial
determined in accordance with EN
60745.
K = Measurement uncertainty value
The vibration emission level given in
this information sheet has been
measured in accordance with a
standardised test given in EN 60745
and may be used to compare one
tool with another.
The vibration emission level will vary because of
the ways in which a power tool can be used and
may increase above the level given in this infor-
mation sheet. This could lead to underestimation
of vibration when the tool is used regularly in such
a manner.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given
period of work should also take into account the
times when the tool is switched off and when it is
running but not actually when doing the job.
This may significantly reduce the exposure level
over the total working period.
Technical modifications reserved
determined according
) 77 dB (A)
pA
) 88 dB (A)
vibration emission
4. Operation
Putting into operation
to
Observe correct main voltage!
Before putting into operation, check that the mains
voltage and frequency on the identification plate
match the details of your mains supply.
Before putting into operation, check the cut-
ting disc for tight seating.
Before switching on, check if the automatic
returning action of the motor unit functions
properly. Push the cutter outlet e.g., against a
table edge until the cutting disc becomes vis-
ible. When the pressure is released, the cut-
ting disc must be completely pulled back into
the base plate.
Connect mains cable module if necessary
level
Mains Cable
If the mains cable is damaged while
working, pull the mains plug immedi-
ately.
Mains cable module
Mains cable module with Patent
Quick Interlock.
Connect the mains cable module 1 to the handle.
The plug must snap in.
Use the mains cable module 1 only for Kress elec-
tric tools. Do not attempt to operate other ma-
chines with the module.
Damaged mains cable modules must not be used.
They must be replaced by a new Kress mains ca-
ble module immediately.
Push the two unlocking buttons 2 and remove the
mains cable module 1 from the handle.
Use only an original Kress mains cable module.
Slip Protection
The two slip protectors 9 prevent the machine
from slipping sideward while routing biscuit
grooves. When routing longitudinal grooves while
guiding the machine sideward, the slip protectors
9 must be set inward by turning them.
English 19
EN
FDF-EN / 0802