KRESS 800 FDF Mode D'emploi page 21

Operation
Replacing the Routing Blade
7
26
Turn the machine around with the base plate 26
facing upward.
Unscrew the four screws 27 and remove the cover
28.
Press the spindle lock button 23.
Loosen the clamping nut 30 with the two-pin span-
ner 29.
Remove the clamping nut 30 and the routing blade
31.
If required, also remove and clean the supporting
flange 32.
Place the routing blade onto the supporting
flange.
Use routing blades size 100 x 4 mm.
NOTE:
Observe the rotation direction of the routing
blade.
Screw the clamping nut onto the spindle. Press
the spindle lock button 23 and tighten the clamp-
ing nut with the two-pin spanner.
-WARNING-
Check if the routing blade is mounted correctly
and moves freely.
Remount the cover 28 and fasten with the four
screws.
Operating tips
Choice of Biscuit Size
Always use the largest possible biscuit size for an
optimal connection. For workpiece thicknesses
above 25 mm, 2 biscuits should be set above each
other.
27
Workpiece
28
thickness
8-12 mm
29
12-15 mm
30
> 15 mm
31
Connection Types
32
The following wood connections/joints are possi-
ble:
Corner joint:
Centre wall joint:
Lengthwise and cross joint:
Biscuit size No. Dimension
0
10
20
Groove-angle setting 0°
Protective router cover 28 mounted
Use of index stop 11
Groove-angle setting 0° and 90°
For vertical routing, remove protective router
cover
Groove-angle setting 0°
Protective router cover mounted
English 21
EN
47 x 15 x 4 mm
53 x 19 x 4 mm
56 x 23 x 4 mm
FDF-EN / 0802