Locking The Controls; Clean Lock Function; Recall Function - De Dietrich DPI7766XP Guide D'utilisation

2
•
USE
fixed for 3 seconds and then the
remaining time is displayed. A beep
sounds to confirm your choice.
This function is available with or
without the timer function.
Note: if the timer is showing a time, it is
not possible to change it within 5
seconds of pressing
seconds, the cooking time can be
changed.

2.8 LOCKING THE CONTROLS

Child safety lock
Your hob has a child safety device
which locks the controls when the hob
is not in use or during cooking (to
maintain the current settings). For
safety reasons, only the stop key and
the zone selection keys are still active
and allow the hob or a cooking zone to
be switched off.
Locking
b
Press key (cadenas), until the "bloc"
locking symbol appears in one of the
displays and a beep confirms the
operation (2.8.1).
Table locked in operation
The display of cooking zones in
operation alternately indicates power
and the locking symbol .
When you press the power or timer keys
for the zones which are «on»:
«bloc» appears for 2 seconds and then
switches off.
Unlocking
b
Press key until the "bloc" locking
symbol disappears from the display and
a beep confirms the operation.

CLEAN LOCK function

This function locks the hob off while it is
being cleaned.
To activate Clean lock:
Give a short press on key
A beep sounds and the «bloc» symbol
flashes in the display.
i
. After 5
After a predefined time, the lock will
automatically disengage. Two beeps
sound and «bloc» switches off. You can
stop the Clean Lock at any moment by
pressing and holding touchkey

2.9 RECALL FUNCTION

This function lets you display the last
«power and timer» settings for all the
burners which were switched off less
than 3 minutes previously.
To use this function, the hob must be
unlocked. Press the On/Off key and then
give a short press on key (2.9)
When the hob is operating, the function
lets you see the power and timer settings
for the burner(s) which have been
switched off for less than 30 seconds.
2.10 FONCTION BOIL
With this function you can boil and
simmer water to cook pasta, for
example.
Select a zone and give a short press on
the "Boil" key (2.10.1)
The default quantity of water displayed is
2 litres, but you can change it using the
+
Set the quantity of water required (from
0.5 to 6 litres).
Confirm by pressing the «Boil» symbol or
wait a few seconds for automatic confir-
27
g
-
or (2.10.2).
b
(padlock).
b
.
k
.
m
.