Behaviour In The Event Of A Power Failure; Adjusting The Ergonomics; Adjusting The Height Of The Pottery Wheel; Adjusting The Seat Longitudinally - Rohde HMT 600 Manuel D'utilisation Original

10.3.

Behaviour in the event of a power failure

If the power fails during operation, the pottery wheel does not restart immediately when the power returns. The
following steps must be carried out so that the machine starts up again.
Step Description
1 Put the foot pedal in the OFF position.
2 Set the selector switch for the direction of rotation to neutral.
3 Set the selector switch for the direction of rotation back to the respective direction of rotation.
4 Operate the foot pedal.
The turntable starts up again.
5
The same procedure also applies if the machine was switched off during operation using the red
Note
"Machine OFF" switch and switched on again using the green "Machine ON" button.
10.4.

Adjusting the ergonomics

10.4.1.

Adjusting the height of the pottery wheel

10.4.2.

Adjusting the seat longitudinally

The distance of the seat from the pottery wheel can be continuously adjusted by loosening the lever clamp. To do this,
the tensioning screw must be loosened anticlockwise and the seat base pulled out or pushed in. Then the clamping
screw must be tightened again in a clockwise direction.
 The lever of the clamping screw can be locked in any position by lifting it.
 If necessary, separate the seat from the pottery wheel to make the length adjustment easier.
 To avoid injuries and damage, the clamping lever must be positioned lengthways to the rear when not in use.
WARNING
Never unscrew the machine feet further than the end of
the scale ("STOP").
The 3 feet of the pottery wheel can be screwed in or out continuously for height
adjustment. The adjustment range is approx. 13 cm in height.
48 / 207 - EN -