Inserting The Power Plug Into The Socket; Notes On The Power Cable; Operation; Switching The Machine On & Off - Rohde HMT 600 Manuel D'utilisation Original

Disconnecting the foot pedal from the machine:
Step Description
Switch off the machine.
1
2 Press the red tab on the round socket on the machine.
3 At the same time, pull the jack plug out of the socket.
8.2.

Inserting the power plug into the socket

INFORMATION
Protection class I device:
The plug of the power cord may only be connected to an earthed socket with a protective
conductor (1 / N / PE).
8.3.

Notes on the power cable

The power cord must not be damaged.

The power cord must not be extended with an extension cord.

Pull the power plug out of the socket before maintenance, troubleshooting, cleaning or repair work.

Only pull the power plug out of the socket when the machine is switched off.

Never connect additional loads to the socket to which the pottery wheel is connected using a power strip.

9.

Operation

9.1. Switching the machine on & off
Switch Description
Machine Switching the machine on:
ON Press the green button on the side of the machine.
Switching off the machine:
Press the red button on the side of the machine.
Machine
 Do not switch off the machine by pulling the plug out of the socket.
OFF
 The red button can also be used to shut down the machine in the
event of incidents or emergencies.
The wheel head does not start moving immediately after switching on.
Note  To do this, the cable of the foot pedal must also be plugged into the machine, the direction of
rotation must be selected, and the foot pedal must be operated.
45 / 207 - EN -
Illustration
Illustration