Symbols Used In The Manual; Safety Warning; Disposal Of Product; Compliance With Ec Regulations - Favero TESTER-A2 Mode D'emploi

Symbols used in the manual

1.3
Parts of the text which are of particular importance
in regards to the safety or proper use of the product
are indicated by the following symbols
Risk of danger or injury to persons if
instructions or the necessary precautions
are not followed.
Important information on product use.

Safety warning

1.4
WARNING! Only use the power supply
adapter/battery charger provided!

Disposal of product

1.5
Please dispose of your product in a manner most compatible
with the environment and in accordance with federal or state
laws, reusing parts and recycling components and materials
when possible.
When this crossed-out waste bin symbol is
attached to a product it signifies the product
should be disposed of in a separate
container from other waste. The sorted waste
collection of the present device is organized
and managed by the manufacturer.
wish to dispose of their present device
should contact the manufacturer and follow
the procedure indicated for separate waste
collection.
Ensuring proper sorted waste collection in
accordance with environmental standards for
the disposal of further devices helps to
protect the environment and the health of
persons from any damaging effects. It also
favors the reuse and recycling of materials.
Administrative sanctions, in accordance with
regulations in effect, will be applied for any
improper or abusive disposal of the product
on part of the holder

Compliance with EC regulations

1.6
The TESTER-A2
requirements for electromagnetic Compatibility and
Security regarding electronic equipment, according
to European regulations:
2004/108/EC of 15 December 2004
•
2006/95/EC of 12 December 2006
•
F E D
AVERO LECTRONIC ESIGN
:
Users
.
meets the necessary
A
2
CTIVATION AND INITIAL SELF
To activate or deactivate the TESTER-A2, press the
ON/OFF button for circa 1 second.
Upon activation, self-calibration will automatically
take place. Should an error signal occur, switch the
TESTER-A2 off and then on again.
If the problem persists, contact Favero. Should an
error occur,
measurements to be taken, with a slight decline in
precision.
P
3
OWER SUPPLY
The TESTER-A2 can be used by either connection
to the main supply via the provided power supply
adapter/battery charger (art. 290-04) or by way of
the internal battery.
The internal battery level status is visible on the first
line of the display, in the upper right-hand corner.
The battery level is correct only if the battery
charger is not connected.
Battery charged 100%
Average duration 10 hrs.
who
Battery charged 75%
Battery charged 50%
Battery charged 25%
Connect the provided battery charger.
Battery depleted, the TESTER-A2 will switch
off automatically.
Connect the provided battery charger.
WARNING! Only use the power supply
adapter/battery charger provided!
Important advice
• Recharge the TESTER-A2 at the end of each
use, or when the battery level is less than 25%.
The complete recharge is after 5-6 hours.
• Do not let the battery empty completely as this
causes it to deteriorate.
• If the TESTER-A2 is not used for a long period of
time, recharge the battery every six months.
Pag. 3 / 36
-
CALIBRATION
the TESTER-A2
00899-M01-03-ML - Manuale TESTER-A2
ENGLISH
allows for