Programming Menu - Favero TESTER-A2 Mode D'emploi

ENGLISH
P
6
ROGRAMMING MENU
To enter into programming, press the [  ] and [  ]
keys at the same time for 1 second.
Press the keys [], [] and [OK] to choose and
select the parameter to be modified.
The flashing digit can be modified with the [] and
[] keys. To move forward one digit, press the
[OK] key; to move back one digit, press the [BACK]
key.
Following is a complete list of parameters that can
be modified. The default values refer to FIE
Technical Regulations (Book 3 – Regulation of
Materials, 2010 edition, revised February 2012).
After completing the modifications, press the [  ]
and [  ] keys simultaneously for 1 second in order
to exit programming, or select "Exit".
P01 – EPEE tip resistance
Rbc: Epee tip resistance
Default value = [2,0Ω]
P02 – EPEE probe resistance
Rpa, Rpb, Rpc: Epee probe resistance
Default value = [2,0Ω]
P03 – EPEE leakage
Rab, Rac: Epee leakage resistance
Default value = [450,0Ω]
P04 – FOIL tip resistance
Rab: Foil tip resistance
Default value = [2,0Ω]
P05 – FOIL probe resistance
Rpa, Rpb, Rpc: Foil probe resistance
Default value = [2,0Ω]
P06 – FOIL leakage
Rac, Rbc: Foil leakage resistance
Default value = [450,0Ω]
P07 – SABRE closed circuit
Rab: Sabre closed/short circuit resistance
Default value = [1,0Ω]
00899-M01-03-ML - Manuale TESTER-A2
P08 – SABRE probe resistance
Rpa, Rpb, Rpc: sabre probe resistance
Default value = [1,0Ω]
P09 – SABRE leakage
Rac, Rbc: Sabre leakage resistance
Default value = [450,0Ω]
P10 – BODYCORD resistance
Raa', Rbb', Rcc': Bodycord resistance
Default value = [1,0Ω]
P11 – BODYCORDS leakage
Rab, Rac, Rbc: Bodycords leakage resistance
Default value = [450,0Ω]
P12 – REEL+CABLES resistance
Raa', Rbb', Rcc': Reel and floor cable
resistance
Default value = [7,0Ω]
P13 – REEL+CABLES leakage
Rab, Rba, Rbc: Reel and floor cables leakage
resistance
Default value = [450Ω]
P14– JACKET resistance
Rjck: Conductive jacket resistance
Default value = [6,0Ω]
P15 – T-SHIRT - Rlow
Rlow: Low threshold of Conductive T-Shirt
Default value = [15,0Ω]
P16 – T-SHIRT - Rhigh
Rhigh: High threshold of Conductive T-Shirt
Default value = [25,0Ω]
P17 – Sound level
Level: buzzer level
0 = OFF (no sound)
1 = middle level
2 = high level
Default value = [2] (high level))
P18 – Weight sensitivity
Sen: Sensitivity to the micro-breaks during
use of weight, in milliseconds (ms)
Default value = [10ms]
Pag. 12 / 36 F E D
AVERO LECTRONIC ESIGN