Agu MFP6 Mode D'emploi page 52

INSTALLATION AND REMOVAL OF THE BLADES
1 Turn the blade (8) as shown in the figure and install the seal ring (9).
2 Hold the blender bowl (7) upside down and insert the blade spindle into the
hole inside the blender bowl. Insert the seal ring onto the blade spindle.
3
Place the blade stand (10) on the blade spindle, holding the blade in posi-
tion inside the bowl.
4 Turn the blade stand (10) a quarter of a turn counterclockwise to secure
the blade in place.
1
IMPORTANT
Pull the blade stand (10) to check that the blade is correctly screwed in.
52
4
3
2