Publicité
Les langues disponibles
Les langues disponibles
GB
F
D
USING THE LASER GUIDE (FOR EWS-1366
ONLY) (FIG. 14)
WARNING
Do not stare into the laser beam or turn the laser
on when the tool is not in use. Failure to do so
could result in possible serious personal
injury.The laser unit comes from the factory
already installed and aligned.
NOTE: Make a trial cut on a piece of scrap to ensure
laser is aligned. Adjusting the laser may be necessary.
Mark the line to be cut on the workpiece.
■
Adjust the depth and angle of the cut as needed.
■
Switch on the laser beam.
■
NOTE: Do not touch the blade to the workpiece until the
saw has reached maximum speed.
Slowly push the saw forward into the workpiece.
■
NOTE: Keep the laser beam on the marked line on the
workpiece for precision cutting.
Once the cut is complete, allow the saw to come to a
■
complete stop before turning off the laser.
LED WORKLIGHTS (FOR EWS-1366 ONLY)
(FIG. 15)
Your saw is equiped with 2 LED WORKLIGHTS (26).
These worklight help illuminate the work piece in dimly
lit areas and helps when following the cutting line.
ADJUSTING THE LASER GUIDE (FIG. 16)
Adjust the laser angle
Rotate the screw clockwise to turn the laser beam to right.
■
Rotate the screw anti-clockwise to turn the laser
■
beam to left.
Adjust the laser position
Rotate the screw anti-clockwise to shift the beam to right.
■
Rotate the screw clockwise to shift the beam to left.
■
MAINTENANCE
After use, check the tool to make sure that it is in top
condition.
We recommended that you take this tool to an Authorised
Ryobi Service Centre for a thorough cleaning and
lubrication at least once a year.
E
I
P
NL
S
DK
N
FIN
GR
English
DO NOT MAKE ANY ADJUSTMENTS WHILE THE
MOTOR IS RUNNING.
ALWAYS DISCONNECT THE POWER CORD FROM
THE SOCKET BEFORE CHANGING REMOVABLE OR
EXPENDABLE PARTS (BLADE, BIT, SANDPAPER,
ETC.), LUBRICATING OR WORKING ON THE SAW.
KEEP HANDLES CLEAN AND FREE FROM OIL AND
GREASE.
WARRANTY
All Ryobi products are guaranteed against manufacturing
defects and defective parts for a period of twenty four
(24) months from the date stated on the original invoice
drawn up by the retailer and given to the end user.
Deterioration caused by normal wear and tear,
unauthorised or improper use or maintenance,
or overload are excluded from this guarantee as are
accessories such as battery packs, light bulbs, blades,
fittings, bags, etc.
In the event of malfunction during the warranty period,
please take the NON-DISMANTLED product, along with
the proof of purchase, to your retailer or nearest
Authorised Ryobi Service Centre.
This warranty in no way affects your legal rights
concerning defective products.
LIVE TOOL INDICATOR
This tool features a live tool indicator (22) which
illuminates as soon as the tool is connected to the supply.
This warns the user that the tool is connected and will
operate when the switch is pressed.
ENVIRONMENTAL PROTECTION
13
H
CZ
RUS
RO
WARNING!
For greater safety and reliability, all repairs should
be performed by an Authorised Ryobi Service
Centre.
Do not dispose of in general household
waste.
Instead,
environmentally friendly way. Contact your
local recycling cetre ou council for advise.
Ryobi takes the care of the envrionment very
seriously.
PL
SLO
HR
TR
dispose
of
in
an
Publicité
