Olympia PS 407.2 CCD Mode D'emploi page 20

5 Operation
The recommended capacities stipulated in Chapter "Technical Data" must
Note:
not be exceeded, otherwise material will jam! Do not forget that the thick-
ness of the paper increases when folded, as a result of which the recom-
mended sheet capacity can be exceeded. Also reduce the quantity of pa-
per when shredding coarse paper.
5.1 Switching the device on
1. Set the On/Off switch to its ON position. The POWER lamp lights up green.
2. The device is ready to operate.
5.2 AUTO function
When the AUTO function is activated, the shredding operation of the cutting mechanism
starts up automatically as soon as material is inserted in the infeed slot:
The device switches to forward drive and draws the material in.
●
When shredding is finished, the device switches off automatically.
●
The AUTO function is automatically activated after switching the device on.
When the AUTO function is activated, you can also shred paper via the
Note:
manual paper infeed and CDs/credit cards/floppy disks via the CD/credit
card/floppy disk infeed. Only one infeed may be used at a time. If you use
more than one infeed, the device stops. Pay attention to the permissible
quantity of material which can be shredded.
5.3 Inserting paper in the manual paper infeed
Maximally 6 sheets of A4 (PS 407.2 CCD) or 15 sheets A4 (PS 417.4
Note:
CCD) with a max. weight of 80 g/m
1. The device is switched on.
2. Insert paper in the manual paper infeed.
2
.
20