EINHELL CC-TJ 2000 Instructions D'origine page 12

9. Troubleshooting
The load cannot be raised with the trolley jack
The trolley jack cannot hold the load in raised
position
The hydraulic system (piston) cannot be
extended to its full height.
The hydraulic system cannot be fully lowered.
Anl_CC_TJ_2000_SPK9.indb 12 Anl_CC_TJ_2000_SPK9.indb 12
Faults
- 12 -
GB
Causes and remedies
The lowering screw has not been tightened.
Tighten the screw clock-wise.
The level of fl uid is too low.
Add more fl uid as described in the instructions.
See No. 1 and No. 2.
The hydraulic system is clogged with dirt.
First close the lowering screw and then open the
vent plug.
Place your foot against a front wheel and pull up
the jacking arm as far it will go.
Lower the jacking arm and try again to raise the
load.
See No. 1 and No. 2.
There is air in the hydraulic system.
Open the vent plug and then remove the air from
the hydraulic system by pumping up and down
several times as described in the instructions.
The return spring is worn or disconnected.
Hook in the spring again. If the spring is too worn
out, replace it. Matching replacement springs are
available from our after-sales service (see 7.2)
05.09.2018 08:07:02 05.09.2018 08:07:02