Opale-Paramodels Backpack M3 Manuel D'utilisation page 27

Remove the CHC M3-16 screws on both sides.
Place the servomotor on the plate and use 4 x CHC
M3-8 screws and nuts.
Position the whole thing as shown on the picture
and tighten the whole thing with CHC M3-20 screws,
washers and nuts.
Power up the servomotor, and adjust the mechanical
end position with your remote to have the arm in the
same position than on the picture shown. The stick
of your radio must be in the middle position (which
is defined as the highest position in your remote
settings).
Position the stick of the your remote downward, the
arm has to have this position.
Notice: think also to watch our tutorials to set your
remote and the Paramixer.
O p a l e - P a r a m o d e l s . c o m
Opale Aero System SARL - 23 rue de la Motte
62250 MARQUISE - France
contact@opale-paramodels.com +33(0)981 144 387
27