Pilot Implementation - Opale-Paramodels Backpack M3 Manuel D'utilisation

Fix the linking rod with 2 x CHC M3-16 screws, 4 wash-
ers and 2 nuts.
Do the same on the opposit side.

Pilot implementation

(sold separately)
Pass the 3 motor wires through the opening located
near the harness zipper.
If this hole is not here you will have to create one with
a soldering iron.
Then connect the ESC with the motor.
Take care though of the motor rotation. If the rotation
as to be reversed, you will only have to switch 2 wires
out of the 3 ( read the ESC manual for further details).
O p a l e - P a r a m o d e l s . c o m
Opale Aero System SARL - 23 rue de la Motte
62250 MARQUISE - France
contact@opale-paramodels.com +33(0)981 144 387
21