Installation Of The Servo Holder Kit - Opale-Paramodels Backpack M3 Manuel D'utilisation

Installation of the servo holder kit

(optional)
Notice: the servo holder kit can be use withou the
landing gear.
Remove the 2 CHC M3-16 screws from the linking
bars and lift up them up.
Position the lower plate on the servo holder kit as it is
shown on the picture.
Then tighten once again the linking bar with the
screws removed earlier. Careful though, the linking
bar must beinserted in the plate hole.
Tighten the upper plate with the lower plate using 2
x CHC M3-16 screws, 4 x washers and 2 nuts.
O p a l e - P a r a m o d e l s . c o m
Opale Aero System SARL - 23 rue de la Motte
62250 MARQUISE - France
contact@opale-paramodels.com +33(0)981 144 387
25