Publicité
Les langues disponibles
Les langues disponibles
screw the cap tightly to prevent leakage.(Fig.8)
WARNING!
RUNNING ENGINE WITH INSUFFICIENT OIL WILL CAUSE SERIOUS ENGINE DAMAGE.
WHEN CHECKING OIL STOP ENGINE AND PLACE IT ON A LEVEL SURFACE.
-
Remove dipstick and wipe clean with cloth.
-
Replace dipstick back without lock it in. Pull the dipstick out and check the oil level.
-
Oil level should be at upper limit on dipstick.
-
If the oil level is near or below the lower limit mark on the dipstick, add oil slowly and
recheck until oil level reaches upper limit of dipstick. DO not overfill.
WARNING!
USING DIRTY OIL OR TWO-STROKE ENGINE OIL WILL SHORTEN ENGINE USEFUL
LIFE.
Fuel:
-
The engine is certifi ed to operate on unleaded petrol with a minimum of 85 octane.
Fresh fuel prevents gum from forming in the fuel system.
-
Do not mix oil with petrol.
-
Keep dust, water and foreign matter away from fuel system.
-
Do not use gasoline which contains Methanol.
Adding fuel:
-
Remove fuel cap.
-
Fill tank to the lowest position of the fuel tank neck.
Do not over fill:
-
Wipe any gasoline that may have spilled.
-
Reinstall the fuel cap.
-
Fuel tank capacity: 3.6L
8. TO START ENGINE
Cold engine start:
A: Move On/Off switch to "On" position.
B. Pull the starter rope until the engine start up.(Fig.9)
C. Move the air lever to the "CLOSE" position.(Fig.10)
D. Move the throttle to the high position.(Fig.11)
E. Pull the starter grip until the engine starts up and go past the air lever slowly to the OPEN
position (normal working position). Put the throttle lever in the down position and let the
engine warm for 1 minute before starting to work.
Warm engine start:
Follow the A & B steps on the Cold engine start. Move the throttle to middle position and pull
the starter grip until it starts.
To stop engine:
Move the throttle lever to the down position and the engine switch OFF. If you put the
19
Publicité
