Ergon SM3 Instructions D'installation Et D'utilisation page 22

22
EN
Correct Positioning
Horizontal adjustment of the saddle must respect the permissible limits as
marked on the rail (fig. 6 on page 19). It is extremely important that the saddle
is not clamped outside of this area, even if the shape of the rails allow it. Most
cases of rails failing are caused by mounting the saddle outside of the permitted
area.
Saddle Care
To clean the saddle of dirt and sweat, it is advisable to use a soft cloth moistened
with water and a little neutral soap. We do not advise the use of pressure
washers. Do not use solvent-base products (oils or creams) on the saddle
covering as they could cause cracking or detaching of the covering. Please note,
the use of some saddle creams could damage the saddle covering. The loss of
colour in some covering materials is not covered by the warranty, as this is
normally caused by UV rays, sweat, heat, moisture. The saddle should be
allowed to dry naturally out of direct sunlight. The saddle may develop noises in
time as dirt is forced into the construction through use. Use a silicon based
lubricant to apply to the affected area. It may be necessary to remove the saddle
and clean the saddle clamp / rails if noises persist.