USRobotics ADSL 4-Port Router Guide D'installation Rapide page 11

Status LEDs
The router has several LEDs on its front. The LED conditions listed below indicate the
operational status of the router.
Solid
Off
Solid
Flashing
Off
Solid
Flashing
Off
Solid
Flashing
(1-4)
Off
Solid
Flashing
Off
The router is powered on.
The router is powered off.
The router is connected to the Internet.
The router is exchanging data with the Internet.
There is no active Internet connection or the device is
in ADSL bridge mode. For information on bridge mode,
see the User Guide on the installation CD-ROM.
An ADSL link is established.
The router is attempting to create an ADSL link.
There is no current ADSL connection.
There is a physical connection between the router and
the computer through the corresponding Ethernet port
(note the port numbers above the LEDs).
The router and computer are exchanging data through
an Ethernet port.
There is no physical connection between the router
and the computer through the Ethernet port.
A printer is connected to the router's USB port. See
the User Guide on the USRobotics installation CD-ROM
for information on using a printer with the router.
NOTE: Do not connect any device other than a self-
powered printer to the USB port. The USB connector
can only be loaded a maximum of 0.11A. Overloaded
operation is hazardous.
The router and printer are exchanging data.
There is no printer connected to the router's USB port.
9