Vectron POS Vario Manuel Utilisateur page 185

Supplemen t
I m p o r ta n t n o tes fo r t h e co n n e c ti o n of sc a l es
• When connecting scales you have to heed the respective natio-
nal regulations. Within the EU it applies: You require a test cer-
tificate for the respective combination of Vectron POS System,
software and scales. The conditions mentioned therein must be
fulfilled.
• Check of certified software
Proceed as follows to check that the Vectron POS system
runs the correct software:
•
•
•
•
•
„Scale generic protocol 02/04 Version 1.01a" must be
displayed (see below).
Switch off the POS system.
Touch the screen and keep it touched.
Switch on the POS system.
Touch the screen until „Starting drivers ..." and then
„Calibration is cleared in n seconds" is displayed.
Touch the „Module inform." button.
185