Vectron POS Vario Manuel Utilisateur page 167

12. Oper a t ion
This chapter gives an overview on the functions of your Vectron
POS system and an introduction into the basic operating proce-
dures. Your Vectron dealer has programmed your POS system to
meet your operating requirements. Some of your operating pro-
cedures may therefore differ from those described in this manual.
Your Vectron dealer will fully explain the functions installed for
you.
• The following operating instructions of the POS system
use the term „key". The Vectron POS ColorTouch, POS
Vario and POS Mini with touch screen allow the applica-
tion of the touch screen. „Key" therefore refers to the
corresponding buttons of the touch screen
• As of version 4.0 of the Vectron POS software the but-
tons on the touch screen display their functions mainly
Notes
by small pictographs, so-called icons. The icons contai-
ned in the Vectron POS software and their meaning are
explained in the supplement.
12 .1 . Si g n i n a n d o u t a t th e P OS sys te m
The operator must sign in to the Vectron POS system in
order to enter PLUs or hold-buffers. Thus you can verify at
any time which operator has made which entries. Different
users can be vested with different authorizations, e.g. void.
There are various possibilities to sign in or out at the Vect-
ron POS system.
167