Other Info Pages - Siemens Synco 700 Mode D'emploi

Other Info pages

To reach the Info pages:
1. Return to the start page by pressing the ESC button.
2. Press the INFO button.
3. Turn the OK knob until the required page appears.
Primary controllerDisplay of the temperature and of the
primary controller's setpoint. Deviations can occur when
consumers are switched on and off.
Time switch
For description of the time switch and its settings, refer
to pages 10 and 11.
Heating circuit
For description of the heating circuit and its settings,
refer to page 8...14 .
(only with RMH760)
Weather data
The actual value outside temp, the actual value solar radiation
and the actual value wind speed are displayed provided the
relevant measured values are delivered.
Siemens Building Technologies Technologies / HVAC Products
(only with RMK770)
Display values
The actual outside temperature is displayed provided the
measured value is delivered. Other displays are possible
(depending on the design of your plant).
(only with RMK770)
Fault inputs
Fault status messages at the fault inputs are displayed
only if configured.
Device state
Displays in the event of fault:
• Source of fault (e.g. B1 pump. B1 stands for boiler 1,
B2 for boiler 2, etc.)
• Error code (important for the heating engineer)
• Date and time of day the fault occurred
Fault status message bus
If your plant includes several interconnected devices,
your controller can display faults of other controllers
(depending on the configuration made).
CE1B3131x2-en 74 319 0346 0 a
29
19.11.2004