Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Internal light
• The type of lamp used for this
appliance is not suitable for household
room illumination.
Care and cleaning
WARNING! Risk of injury or
damage to the appliance.
• Before maintenance, deactivate the
appliance and disconnect the mains
plug from the mains socket.
• This appliance contains hydrocarbons
in the cooling unit. Only a qualified
person must do the maintenance and
the recharging of the unit.
• Regularly examine the drain of the
appliance and if necessary, clean it.
If the drain is blocked, defrosted water
collects in the bottom of the appliance.

INSTALLATION

Installation location
The appliance should be set up in a
wellventilated, dry room.
Energy use and efficient performance of
the appliance is affected by the ambient
temperature.
The appliance should therefore not be
exposed to direct sunlight;
Do not be installed next to radiators,
cookers or other sources of heat; only
be installed at a location whose ambient
temperature corresponds to the climate
classification, for which the appliance is
designed.
The climate classification can be found on
the serial plate, which is located at the left
on the inside of the appliance.
The appliance must be positioned so
that the plug is accessible. The following
table shows which ambient temperature
is correct for each climate classification:
Climate
­ c lassification
SN
N
ST
T
For an ambient
temperature
+10 to +32°C
+16 to +32°C
+16 to +38°C
+16 to +43°C
Disposal
WARNING! Risk of injury or
suffocation.
• Disconnect the appliance from the
mains supply.
• Cut off the mains cable and discard it.
• Remove the door to prevent children
and pets to be closed inside of the
appliance.
• The refrigerant circuit and the insulation
materials of this appliance are ozone-
friendly.
• The insulation foam contains flammable
gas. Contact your municipal authority
for information on how to discard the
appliance correctly.
• Do not cause damage to the part of
the cooling unit that is near the heat
exchanger.
If the refrigeration appliance is installed
next to another refrigerator or freezer a
clearance of 5cm at the sides is required,
in order to prevent the formation of
condensation on the outside of the
appliance.
Your refrigerator needs air
For correct operation this appliance must
be located in a dry atmosphere, away
from heat sources, e.g. cookers, radiators,
boilers and direct sunlight.
You should also ensure that air can
circulate freely around the back and
the top of the cabinet. There should be
100mm between the top of the cabinet
and any overhanging kitchen furniture.
Alternatively allow 50mm between the
top of the cabinet and any overhanging
kitchen furniture and a gap of 25mm on
either side of the appliance.
Reversing the door
This refrigerator has the capability of
either opening the door from the left or
right side. This unit is delivered to you
with the door opening from the left side.
Should you desire to reverse the opening
direction, please follow these instructions.
5

Publicité

Chapitres

Table des Matières
loading

Table des Matières