Correcting Malfunctions; Changing The Light Bulb - ARTHUR MARTIN ART1000AOW Notice D'utilisation

CORRECTING MALFUNCTIONS

Spare parts
The following spare parts can be ordered
from your local AEG Service Force
Centre. You can fit these yourself without
any special skill ortraining, e.g.:
• Butter/cheese compartment,
egg holders,
• Door racks,
• Fruit and vegetable drawers,
• Storage racks.
A malfunction may be caused by only
a minor fault that you can rectify yourself
using the following instructions.

CHANGING THE LIGHT BULB

WARNING! There is a risk of
electric shocks! Before changing
the light bulb, switch off the
appliance and unplug it, or pull the
fuse or the circuit breaker.
Light bulb data: 220~240 V, max. 15 W
To switch off the appliance, turn the
temperature regulator to position "0".
Unplug the mains plug.
To change the light bulb, undo the screw.
Press the light bulb cover as shown and
slide it backwards.
Change the defective light bulb. Refit
thelight bulb cover and the screw.
Put the refrigerator back into operation.
Do not perform any other work on the
appliance if the following information does
not provide assistance in your specific
case.
IMPORTANT! Repairs to
refrigerators/freezers may only be
performed by competent service
engineers. Improper repairs can
give rise to significant hazards
for the user. If your appliance
needs repairing, please contact
your specialist dealer or your local
Service Force Centre.
Noises during operation
The following noises are characteristic of
refrigeration appliances:
Clicks
Whenever the compressor switches on or
off, a click can be heard.
Humming
As soon as the compressor is in operation,
you can hear it humming.
Bubbling
When refrigerant flows into thin tubes, you
can hear
Splashing
Bubbling or splashing noises. Even after
the compressor has been switched off,
this noise can be heard for a short time.
13