Trouble Shooting - ARTHUR MARTIN ART1000AOW Notice D'utilisation

12

TROUBLE SHOOTING

Symptom
Appliance does not work.
Appliance cools too much.
The food is too warm.
Interior lighting does not work.
Heavy build-up of frost,
possibly also on the door seal.
Unusual noises.
The compressor does not start
immediately after changing the
temperature setting.
Water on the floor or storage
shelves.
Possible Cause
Appliance is not switched on.
Mains plug is not plugged in
or is loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
Door seal is not air-tight
(possibly after reversing
the door).
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
This is normal, no error has
occurred.
Water drain hole is blocked.
Remedy
Switch on the appliance.
Insert mains plug.
Check fuse, replace
if necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature
regulator to a warmer setting
temporarily.
Please look in the "initial Start
Up" section.
Open the door only as long as
necessary.
Turn the temperature
regulation to a colder setting
temporarily.
Please look in the "installation
location" section.
Please look in the "changing
the Light Bulb" section.
Carefully warm the leaking
sections of the door seal with
a hair dryer (on a cool setting).
At the same time shape the
warmed door seal by hand
such that it sits correctly.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
The compressor starts after
a period of time.
See the "cleaning and care"
section.