Interior Accessories - ARTHUR MARTIN ART1000AOW Notice D'utilisation

8
The temperatures in the refrigerator
compartment and freezer compartment
cannot be independently regulated.
At a low ambient temperature of around
16°C, setting '1' should be selected. At
ambient temperatures of around 25°C ,
select setting '2'.
If you require a lower temperature, select
setting '3' or '4'. On this setting, you can
be sure the fresh food will be reliably
frozen and that a storage temperature
of -18°C will be maintained in the freezer
compartment. If you want the freeze fresh
food rapidly, select setting '7',ensuring
that the temperature in the refrigerator
compartment does not drop below 0°C.
You should also promptly reset the
temperature regulator to setting '3' or '4'.

INTERIOR ACCESSORIES

Storage shelves/wire trays
Various glass or plastic storage shelves
and wire trays are included with your
appliancedifferent models have different
combinations. You should always slide
one of the full size glass storage shelves
into the lowest set of guides, above the
Correct storage
1 Butter and cheese
2
Preserves
3
Drinks
4
Cheese storage, fruit, and vegetables
5
Meat, salami, cold cuts, dairy produce
6
Ready meals, pastries, preserves
7 Frozen food storage/freezing food
IMPORTANT! High ambient
temperatures (e.g. on hot
summer days) and a cold setting
on the temperature regulator
(position '6' to '7') can cause the
compressor to run continuously.
Reason: when the ambient temperature
is high, the compressor mustrun
continuously to maintain the low
temperature in the appliance. The fridge
will not be able to defrost since automatic
defrosting of the fridge is only possible
when the compressor is not running
(see also 'Defrosting' section). The result
is the build up of a thick layer of frost on
the fridge rear wall.
If this happens, turn the temperature
regulator back to a warmer setting
(position '3' to '4'). At this setting the
compressor will be switched on and
off as usual and automatic defrosting
recommenced.
fruit and vegetable containers, and keep
it in this position. The height of the storage
shelves can be adjusted:
To do this pull the storage shelf forward
until it can be swivelled upwards or
downwards and removed.
Please do the same in reverse to insert
the shelf at a different height.