Adjusting Of The Pushing Handles; Adjusting Of The Tip Cap - Vermeiren Eclips+ Mode D'emploi

3.10 Adjusting of the pushing handles

WARNING:
Risk of injury - Make sure that all screws are properly tightened with
L
the appropriate tool.
WARNING:
L Risk of tipping over - Make sure that the tubes of the pushing
handles are positioned identically on both sides.
3.10.1 Pushing handles for the Eclips+
3.10.2 Pushing handles / Back adjusting for the Eclips+ 30°
1
1
4
3
3
2
2

3.11 Adjusting of the tip cap

WARNING:
L Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
A tip cap is mounted on the lower right back frame that can be adjusted in its height
depending on the seat height of the wheelchair.
The tip cap can be placed in 2 different position with a difference of 15 mm (0.59 in.). (The
wheelchair with seat height 500 mm (19.69 in.) is the tip cap height adjustable in 150 mm
and 165 mm (5.91 in. and 6.50 in.)).
The tube handle Ⓐ is fixed to the back frame Ⓑ.
Adjust the height of the pushing handles as follow:
1. Remove the arm supports.
2. Remove the screws Ⓒ.
3. Remove the screws Ⓓ for suspending the
armrests.
4. Pull the tube handle to the desired height.
Pusing handle height Tube handles Ⓐ
910 mm (35.83 in.)
(Standard)
925 mm (36.42 in.)
940 mm (37.00 in.)
955 mm (37.60 in.)
970 mm (38.19 in.)
985 mm (38.78 in.)
1000 mm (39.37 in.)
1015 mm (39.96 in.)
Table 4: Pushing handle heights
5. Retighten all the fixing screws Ⓒ,Ⓓ properly.
With the model Eclips+ 30° you can adjust the height
of pushing handles  in back tube .
1. Loosen the Philips screw .
2. Set the pushing handles to the required height.
3. Retighten the Philips screw  again.
Page 22
Eclips+, Eclips+ 30°
Tube frame Ⓑ
Hole 9 and 11 Hole 1 and 2
Hole 8 and 10 Hole 1 and 2
Hole 7 and 9 Hole 1 and 2
Hole 6 and 8 Hole 1 and 2
Hole 5 and 7 Hole 1 and 2
Hole 4 and 6 Hole 1 and 2
Hole 3 and 5 Hole 1 and 2
Hole 2 and 4 Hole 1 and 2
2011-05