Fermax DUOX Manuel D'installation page 49

REGISTERING FRAMES IN PC MODE (IM)
This advanced DUOX programmer function allows the registering of all commands generated
in an installation for an unlimited period of time.
Its useful, for example, if there are problems in an installation that can not be analysed and
discovered on-sight, and requires the registry of all activity of all commands generated for
a determined amount of time for the personnel from the Technical Department in the factory.
This requires a PC to which the programmer must remain connected to during this time,
and where all these commands will be registered.
If this function is necessary, Fermax´ technical support will indicate the necessary
details for this operation, along with sending the drivers and necessary utilities.
For this connection you must assign the COM port created upon connecting the device,
and configure the parameters of this port as follows:
-Baud Rate: 115200
-Parity: none
-Data bits: 8
-Stop bits: 1
-No parity control
Once the PC is prepared, to use this function follow these steps indicated in the diagram:
4. SNIFFER PC
4. SNIFFER PC
N.CMD RX: 00000
We start from option 4,
SNIFFER PC, from the MAIN MENU
OK
The lower row indicates the number of
commands that have been transmitted
to the PC