Dometic CK150 Instructions De Montage Et De Service page 12

Mounting the extractor hood
I
NOTE
Pull the fan on tightly enough that the rubber seal is seamlessly in contact
with the roof.
➤ Attach the fan (fig. 5 3, page 4) with the six included bolts (4.2 x 25).
➤ Attach the roof hood (fig. 5 2, page 4) with the three included bolts (3.5 x 9.5).
➤ Attach the cover cap (fig. 5 1, page 4) with the three included bolts (4.2 x 13).
6.2 Mounting the extractor hood
!
WARNING!
• Attach the extractor hood preferably over the cooking zone and
install it in a a suspended cabinet.
• The distance between the gas hob flame and the extractor hood
must be at least 50 cm.
➤ Choose a suitable installation location in the interior for the extractor hood.
➤ Draw the location and size of the section of 381 x 142 mm on the bottom of the
suspended cabinet (fig. 4, page 4).
➤ Pre-drill and cut out the section carefully with a keyhole saw or similar tool.
➤ Insert the extractor hood from below into the cabinet and secure it with the four
included bolts (3.5 x 13) (fig. 6, page 5).
➤ Attach the hose (fig. 6 3, page 4) to the extractor hood (fig. 6 5, page 4) and
the fan (fig. 6 1, page 4) with the hose clips (fig. 6 2 and 4, page 4).
➤ Insert the filter (fig. 2 1, page 3) into the extractor hood.
6.3 Connecting the extractor hood electrically
➤ Connect the fan to the battery; see fig. 7, page 6.
Key
No. in
fig. 7,
Description
page 6
1 Fan
2 Fuse holder with fuse T4 A 5 x 20 mm
12
CK150
EN