dirna Bergstrom Bycool Compact 1.4 Instructions De Montage page 16

COMPACT 1.4
EN
7
With the plate attached to the cab, thread
10 mm (4) M8 studs into the base of the
equipment. On these studs insert (1) rubber
washer, (1) Ø 8 flat washer, (1) M8 nut and
tighten against the base.
7
8
Place the equipment on the hatch plate
ensuring the base studs coincide with the holes
on the hatch plate. Insert (4) M8 flat washers
and (4) self-locking M8 nuts and tighten until
the metal plate is right up to the inside nut.
9
Place channelling duct (*) screw (4) 10 mm
M6 studs with (4) M6 rubber washers, (4) M6
flat washers and (4) M6 nuts. Then tighten the
nut against the base of the equipment.
9
*
9
7
8
9
16
Rubber washer in
contact with the
base.
Rubber
washer
Wide-brimmed
washer
M6 Nut
®