Figure 3.5: Devices Dialog Box; Figure 3.6: Device Modify Dialog Box - Avocent AutoView 1400 Guide D'installation Et D'utilisation

22 AutoView 1400/1500/2000 Installer/User Guide

Figure 3.5: Devices Dialog Box

When the AutoView switch discovers a cascaded switch, you will notice the port numbering
change to accommodate each server under that switch. For example, if the switch is connected to
ARI port 6, the switch port would be listed as 06 and each server under it would be numbered
sequentially 06-01, 06-02 and so on.
To assign a device type:
1. In the Devices dialog box, select the desired port number.
2. Click Modify. The Device Modify dialog box displays.

Figure 3.6: Device Modify Dialog Box

3. Choose the number of ports supported by your cascaded switch and click OK.
4. Repeat steps 1 to 3 for each port requiring a device type to be assigned.
5. Click OK in the Devices dialog box to save settings.
NOTE: Changes made in the Device Modify dialog box are not saved until you click OK in the Devices
dialog box.