Operating Yourwine Cooler - Avintage AV79XDZI-1 Notice D'utilisation

Turn around the glass door 180° and refit the hinge pin ③&⑧ through the top hinge plate ⑥ and lower hinge plate ⑦
5.
into the door. Make sure that the spacers which the hinge pins sit on are correctly positioned.
6. Leveling the door by adjusting the screws that are used to fix the top hinge plate and lower hinge plate.
OPERATING YOURWINE COOLER
The Wine Cooler should be placed in a position where the ambient temperature is between 16-32°C/60~95ºF. If the ambient
temperature is above or below this range, the performance of the unit may be affected. For example, placing your unit in
extreme cold or hot conditions may cause interior temperatures to fluctuate. The range of 5-18°C/40-72ºF may not be
reached.
Note:
When you use the Wine Cooler for the first time or restart the Wine Cooler after having been shut off for a long time, there could be
a few degrees variance between the temperature you select and the one indicated on the LED readout. This is normal and it is due to
the length of the activation time. Once the Wine Cooler is running for a few hours everything will be back to normal.
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart
before this time delay, the Wine Cooler will not start.
THE CONTROLS OF YOUR WINE CELLAR
POWER
To control this appliance turn on/off. To turn OFF the appliance, touch the
seconds.
SET
To set or view the internal temperature setting for each zone.
LIGHT
To control the inner light turn on/off.
UP
Used to raise (warm) the set temperature by 1°C or 1ºF.
DOWN
Used to lower (cool) the set temperature by 1°C or 1ºF.
ºF/ºC Selector
Select the temperature display setting in Fahrenheit or Celsius degree. To change the temperature from
Fahrenheit to Celsius or from Celsius to Fahrenheit, touch the
and marks at the same time for 5
and marks at the same time for 5 seconds.
20