Installing The Handle; Reversing The Door Swing Of Your Appliance - Avintage AV79XDZI-1 Notice D'utilisation

INSTALLING THE HANDLE
REVERSING THE DOOR SWING OF YOUR APPLIANCE
Should you desire to reverse the opening direction, please follow the instructions below.
1
2
Note: All parts removed must be saved to do the reinstallation of door.
Close the glass door, and remove the decoration plug ②. Unscrew the top hinge pin ③ and lower hinge pin ⑧. Be
1.
careful to support the glass door with hands to prevent it from dropping after removing the pins. (Figure 1&2)
2. Pull down to remove the glass door and place it on a padded surface to prevent scratching it.
Remove the right top hinge plate ④ by unscrewing the four screws ① and get the left top hinge plate ⑥ from the plastic
3.
bag that includes the instruction manual then install it at the designated position on the opposite side. (Figure 1)
Remove the lower hinge plate ⑦ by unscrewing the four screws ⑨. Then turn it around and refit it on the opposite
4.
side.(Figure 2)
1. Remove the door gasket on the side you wish to install
the handle - you can see two designated holes for
handle installation.
2. Install the handle tightly as shown above with two
screws, lock washers and flat washers provided.
3. Replace the door gasket.
① Screw
② Decoration Plug
③ Top Hinge Pin
④ Right Top Hinge Plate
⑤ Glass Door
⑥ Left Top Hinge Plate
⑦ Lower Hinge Plate
⑧ Lower Hinge Pin
⑨ Screws
⑩ Cabinet
19