Inserting The Battery - Hama EWSC-100 Mode D'emploi

G Operating instruction
Controls and Displays
1. Display
2. Temperature trend display (h/°C)
3. MAX/MIN button = used to display the stored maximum/minimum
indoor and outdoor temperature values
4. DOWN button (decrease set value)
5. UP button (increase set value)
6. ALARM button
7. MODE button
8. LIGHT button (display light)
9. Outdoor sensor
10. Opening for wall mounting
11. Stand
12. Battery compartment cover
13. Outdoor temperature display
14. Indoor temperature display
15. Four-level weather visualisation
= sunny, partly cloudy, cloudy, rainy
16. Humidity display (as %)
17. Time
18. Days of the week
19. Comfort display
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw your
attention to speci c hazards and risks.
Note
This symbol is used to indicate additional information or important
notes.
2. Package Contents
• Electronic Weather Station
• 3 x AAA batteries
• These operating instructions
2
3. Safety Notes
• The product is intended for private, non-commercial use only.
• Protect the product from dirt, moisture and overheating, and only use
it in a dry environment.
• Do not use the product in areas where the use of electronic devices is
not permitted.
• Do not use the product in the immediate vicinity of heaters or other
heat sources or in direct sunlight.
• Do not drop the product and do not expose it to any major shocks.
• Do not attempt to service or repair the product yourself. Leave any and
all service work to quali ed experts.
• Do not modify the product in any way. Doing so voids the warranty.
• Keep the packaging material out of the reach of children due to the
risk of suffocation.
• Dispose of packaging material immediately according to locally
applicable regulations.
Warning – Batteries
• Immediately remove and dispose of dead batteries from the
product.
• Only use batteries (or rechargeable batteries) that match the
speci ed type.
• Do not mix old and new batteries or batteries of a different type
or make.
• When inserting batteries, note the correct polarity (+ and -
markings) and insert the batteries accordingly. Failure to do so
could result in the batteries leaking or exploding.
• Do not overcharge batteries.
• Do not overcharge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/rechargeable batteries and keep
them away from uncoated metal objects
4. Getting Started

4.1 Inserting the battery

• Remove the battery that was already inserted into the clock, remove
the protective lm if necessary as well as the contact interrupter and
the re-insert the battery with the correct polarity. The clock is ready
for operation.