W Arning - Batteries; Inserting The Batteries; Replacing The Batteries; Base Station - Hama EWS-165 Mode D'emploi

arning – Batteries
W
• Immediately remove and dispose of dead batteries from
the product.
• Only use batteries (or rechargeable batteries) that match the
specified type.
• Do not mix old and new batteries or batteries of a different
type or make.
• When inserting batteries, note the correct polarity (+ and -
markings) and insert
the batteries accordingly. Failure to do so could result in the
batteries leaking or exploding.
• Do not charge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/rechargeable batteries and
keep them away from uncoated metal objects.
4. Getting Started

4.1. Inserting the batteries

Measuring station

• Open the battery compartment (24) and remove the contact
breaker. Replace the battery compartment cover.

Base station

• Open the battery compartment (23) and remove the contact
breaker. Replace the battery compartment cover.

4.2. Replacing the batteries

Measuring station
• Open the battery compartment (24), remove and properly
dispose of the dead batteries and insert two new AAA batteries
with the correct polarity. Replace the battery compartment cover.
Base station
• Open the battery compartment (23), remove and properly
dispose of the dead batteries and insert two new AA batteries
with the correct polarity. Replace the battery compartment cover.
ote
N
Before use, ensure you insert the batteries in the measuring
station first and then in the base station.
5. Installation
ote – Installation
N
• We recommend initially placing the base and measuring
stations in the intended locations without installing them and
making all the settings described in
6. Operation
– to do.
• Only install the stations once the appropriate settings have
been made and a stable wireless connection is established.
ote
N
• The wireless transmission range between the measuring and
base stations is up to 30 m in open spaces.
• Before installation, ensure that wireless transmission will not
be disrupted by interference or obstacles like buildings, trees,
vehicles, high-voltage lines, etc.
• Before the final installation, ensure that there is sufficient
reception between the intended installation locations.
• When installing the measuring station, ensure that it is
protected from direct sunlight and rain.
• The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
arning
W
• Buy special or suitable installation material from a specialised
dealer for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during installation. This could damage
the product.
• Before installation, ensure that the chosen wall is suitable for
the weight to be mounted, and make sure that there are no
electrical wires, water, gas or other lines at the installation
site on the wall.
5.1. Base station
• Use the base (22) to position the base station on a level surface.
• Alternatively, you can install the base station on a wall using the
opening (21) on the back.
5.2. Measuring station
• You can fasten the measuring station horizontally or vertically to
an outer wall using a mounting plate (25).
• If you want to mount the measuring station horizontally, use
rawl plugs, screws, etc. to fasten the mounting plate (25) using
the central cut-out (27) to the wall intended for installation.
• If you want to mount the measuring station vertically, use rawl
plugs, screws, etc. in the wall intended for installation and hang
the mounting plate (25) using cut-out (26).
• Gently push the measuring station until you hear a latching
sound ("click") as it engages with the clips (28).
6. Operation
ote – Input
N
Hold down the ▲ button (16) or the  button (14) to
select the values faster.
6.1. Connection to the measuring station
• After you insert the batteries, the base station automatically
searches for a connection to the measuring station and performs
initial setup.
3