Sharp XV-Z3000U Mode D'emploi page 18

4. Turn the video equipment on and start playback
5. Select the INPUT mode
Select the "INPUT 4" using the INPUT buttons on the projector or the INPUT 4 button on the
remote control.
• When pressing the INPUT buttons on the projector, input mode switches in the following
INPUT1
order:
• Pressing the INPUT buttons on the remote control also allows you to switch the input mode.
6. Adjust the focus, image size, and projector angle
1. Adjust the focus by
turning the focus ring.
Focus ring
7. Correct trapezoidal distortion (GEOMETRIC ADJUSTMENT)
1. Press c KEYSTONE on the remote control.
2. Press P/R/O/Q on the remote control to set the upper-left position of the projected image.
3. Press i ENTER on the remote control to set the position.
4. Follow steps 2 and 3 to also set the upper-right, lower-right, and lower-left positions of the
projected image.
• When you confirm the lower left position, the screen adjustments will be set and setup will
end.
8. Turn the Power off
Press the STANDBY/ON button on the projector or the STANDBY button on the remote control,
and then press the button again while the confirmation message is displayed, to put the projector
into standby mode.
On the
projector
• Unplug the power cord from the AC outlet after the cooling fan stops.
On the On the remote
projector control
INPUT2 INPUT3 INPUT4
2. Adjust the projection
image size by turning
the zoom ring.
On the remote
control
On-screen display
INPUT 4
INPUT5 INPUT6
3. Adjust the projector
angle using the HEIGHT
ADJUST lever.
Zoom ring
On-screen Display
_P. 29
_PP. 30, 31
_PP. 32–35
_P. 29
17