LawnMaster LMRM1601 Guide D'utilisation page 15

MAINTENANCE
CAUTION
Αdjusting the screws for blade adjustments is a very sensitive procedure. A sixteenth of a turn is
considered a major adjustment. Βefore tightening one adjustment screw, make sure to loosen the
opposite screw an equal amount.
■ To test for proper adjustment:
a. Lean the mower all the way back so that it is resting on the handle.
b. Use one hand to slowly rotate the wheel of the mower, causing the blade reel to slowly turn.
If the wheel is too difficult to turn, slightly loosen each adjustment screw.
c. While the blade reel is turning, insert a sheet of paper between the blade reel and the cutting bar.
The paper should shear evenly along the entire length of the cutter bar, as if being cut by
scissors. If the paper does not shear, slightly tighten each adjustment screw and repeat the
test.
15