LawnMaster LMRM1601 Guide D'utilisation page 14

MAINTENANCE
MOWER BLADE ADJUSTMENT
The blade reel is adjusted for proper clearance from the cutting bar at the factory. However, after
extended periods of mowing or as part of annual maintenance, it is recommended that the blade
clearance be readjusted. Use a 6mm hex key for adjusting (not included).
■ If the blade clearance is too wide, the cutting pattern will be rough and uneven.
■ If the blade clearance is too narrow, the machine will be noisy and difficult to push while operating.
To adjust the blade clearance, proceed as follows:
■ Locate the adjustment bolts found on the underside of the cutting bar on the rear of the mower.
■ Using a hex key, tighten the adjustment bolts (one on each end) 1/4 turn (Fig. 6).
WARNING
Do not over-tighten the adjusting screws, as this could damage the cutter bar. Tighten both screws
during final adjustment.
Fig. 6
14