DeWalt D55140 Guide D'utilisation page 17

CODE POSSIBLE CAUSE
16 Loose electrical connections
17 Possible defective motor.
18
Fuse blown, circuit breaker tripped
19 Tank pressure exceeds pressure switch cut-in pressure
POSSIBLE SOLUTION
Contact a D WALT factory service center or a D
E
authorized service center.
Contact a D WALT factory service center or a D
E
authorized service center.
1. Check fuse box for blown fuse and replace as necessary.
Reset circuit breaker. Do not use a fuse or circuit breaker
with higher rating than that specified for your particular
branch circuit.
2. Check for proper fuse. Use only a time delay fuse.
3. Check for low voltage conditions and/or proper extension
cord.
4. Disconnect the other electrical appliances from circuit or
operate the compressor on its own branch circuit.
Motor will start automatically when tank pressure drops
below cut-in pressure of pressure switch.
17
WALT
E
WALT
E