Water Flush Setting - Scotsman C1448 Manuel De L'utilisateur

C1448, C1848, C2148W
Air and Water Cooled User Manual

Water flush setting

The water flush is factory set to the automatic
position, suitable for most water conditions. The
setting can be changed to one of 5 manual settings
or left on automatic.
Flush 1 -
setting Minimum
RO water
Water
or
Type
equivalent
Status De-Scale
Power Water
To set:
1 Switch the machine OFF by holding the Off
button in until a number or the letter A shows
on the display.
2 Press and release the On button repeatedly
until the number on the display corresponds to
the desired setting.
3 Press and release the Off switch again to
return to the normal control state.
2 - 3 -
Moderate Standard
Factory
Setting for
typical
water
Off
On
November 2006
Page 12
5 -
4 - Heavy
Maximum
High TDS
water
A - Automatic
Any with
conductivity not
less than 10
microSiemens/cm