Geberit AQUACLEAN Mera Classic Instructions De Montage page 48

Masquer les pouces Voir aussi pour AQUACLEAN Mera Classic:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 56
EN
If the status LED flashes red:
• Test whether the water supply has been
established. Open ball valve.
• Reset storage water heater. → See
"Resetting the storage water heater",
page 52
• switch off device, wait 30 seconds and
then switch device back on.
If the status LED continues to flash red
after taking these measures, contact
customer service.
48
Putting the remote control into
operation
If several devices of the same type are
installed in immediate proximity (e.g. in
hotels), the remote control must be
assigned. → See "Re-assign remote
control", page 49.
Prerequisite
– The function test of the device was performed
successfully.
Open the battery compartment and insert
battery.
Result
✓ The display shows [Pairing ok] for 10 seconds.
If the [Pairing ok] message does not
appear, re-assign remote control. → See
"Re-assign remote control", page 49.
9007203612975499-1 © 11-2018
968.543.00.0 (00)

Publicité

Table des Matières
loading

Table des Matières