After Installing The Unit - Pioneer AVIC-X1 Manuel D'utilisation

After Installing the Unit

1. Reconnecting the battery.
First, double-check that all connections are correct and that the unit is installed correctly.
Reassemble all vehicle components that you previously removed. Then reconnect the neg-
ative (–) cable to the negative (–) terminal of the battery.
2. Start the engine.
3. Press the RESET button on the display unit.
Press the RESET button on the display unit using a pointed object such as the tip of a pen.
4. Enter the following settings:
• Install the program in the navigation system.
• Drive until the initialised sensors start operating normally.
• Set the time and language.
Set the navigation system as explained in the "Operation Manual" or "Hardware Manual".
Note:
If you reconnected the Hide-away unit, press the RESET button.
After installing the unit, be sure to check at a safe place that the vehicle is performing
normally.
29