Rexel REM 820 Manuel D'utilisation page 5

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
Installation
Position the basket into the shredder. Once the basket is
correctly positioned in the machine, plug it into a standard
AC outlet.
Correct operating procedure
Position the CD bin into place on top of the paper bin.
1
2
Insert the plug into the AC power socket.
Press the power switch at the side of the shredder to the ON (I)
3
position.
When not in use, press the switch to the 'O' position (off position).
4
Auto shred and stop
• Place the paper (fig 4) or credit card/CD (fig 5/6) into the centre of the
entry slot - shredding will start automatically.
• Paper smaller than A4 in width should be placed in the middle of the
entry slot to ensure the shredder works automatically.
• The cutters will stop rotating automatically after finishing shredding
• Do not shred more than the stated sheet capacity at a time.
Forward and reverse
In case of jammed paper, please follow the procedure below:
Check if the bin is too full with paper - the bin should be emptied
1
regularly to avoid paper becoming jammed in the cutters.
Press the switch,
position, to reverse the jammed paper.
2
If the paper is jammed to such an extent that it will not come out
3
using the reverse function, press the switch alternately in the
and
position. Don't do this too quickly as this can damage the
shredder.
WARNING – Do not under any circumstances use any metal objects
4
(scissors, letter openers etc.) in an attempt to clear the entry – this
model has mains voltage inside the casing, which could cause
serious injury.
Warranty
ACCO Brands Europe (ACCO) warrants its products and their parts
against defects in materials and workmanship under normal use for a
period of 24 months from the original date of purchase.
During this period we will repair or replace a defective product or part
subject to the following warranty conditions:
The warranty applies only to defects in materials and workmanship
under normal use and does not extend to damage to the Product or
parts which result from:-
- alteration, repair, modification or service carried out by anyone other
than an authorised ACCO service centre.
- accident, neglect, abuse or misuse owing to failure to comply with the
normal operating procedures for a product of this type.
Register this product online at www.accobrands.com
Troubleshooting
If the paper shredder will not start, please check the following:
1
Is the machine plugged in correctly?
Is the switch pushed to the ON (I) position?
2
Is the machine jammed with paper?
3
Has the motor overheated?
4
1 2 3
Is the shredder bin fully pushed in?
5
This machine does not require lubricant. Acco Brands Europe accepts no
liability for product performance or safety should any lubricant be used
on any part(s) of this machine.
Waste Electrical and Electronic
Equipment (WEEE)
4 5 6
At the end of its useful life, your product is considered to be WEEE. As
such, it is important to note that:
WEEE is not to be disposed of as unsorted municipal waste. It is to be
collected separately such that it can be disassembled so its components
and materials can be recycled, re-used, and recovered (burned for
energy content in the production of electricity).
Public collection points have been set up by municipalities for the
collection of WEEE, free of charge to you.
Please return your WEEE to the collection facility nearest your home or
7 8 9
office.
If you have difficulty locating a collection facility, the retailer that sold you
the product should accept your WEEE.
If you are no longer in contact with your retailer, please contact ACCO for
assistance with this matter.
Recycling of WEEE is geared toward protecting the environment,
protecting human health, preserving raw materials, improving
sustainable development, and ensuring a better supply of commodities
in the European Union. This will be achieved by retrieving valuable
secondary raw materials and reducing the disposal of waste. You can
contribute to the success of these goals by returning your WEEE to a
collection facility.
Your product is marked with the WEEE symbol (wheelie bin with an
X through it). This symbol is to inform you that the WEEE is not to be
disposed of as unsorted municipal waste.
Depending on the diagnostics and the model type, we will either arrange
a service call by an engineer or arrange with you return of the product to
ACCO. ACCO will, at its discretion, in accordance with law, either
- repair the shredder using either new or refurbished parts, or
- replace the shredder with a new or refurbished shredder that is
equivalent to the shredder being replaced.
Nothing in this Warranty shall have the effect of excluding the liability of
ACCO in respect of death and personal injury caused by the negligence
of ACCO. This Warranty is offered (subject to these terms and conditions)
in addition to, and does not affect, your statutory rights.
If you experience a technical fault, please contact the ACCO customer
helpdesk (see back cover).
G
5

Publicité

Table des Matières
loading

Table des Matières