Waste Disposal; Bartscher Gmbh Franz-Kleine-Str - Bartscher Compact Ice K 100073 Mode D'emploi

PROBLEM
The ice cube making
process is normal but
does not produce any
ice cubes
The ice cube making
process has stopped
automatically

8. Waste disposal

Discarding old devices
At the end of its service life the discarded device has to be disposed in accordance with
the national regulations. It is advisable to contact a company which is specialized in
waste disposal, or just contact the local disposal service in your community.
WARNING!
To exclude any abuse and the dangers involved make the waste device unfit for
use before disposal. For that purpose disconnect device from mains supply and
remove mains connection cable from the device.
NOTE!
Bartscher GmbH
Franz-Kleine-Str. 28
D-33154 Salzkotten
Germany
- 28 -
POSSIBLE CAUSES
The ambient temperature or
the water temperature in
the container is too high.
The cooling agent has
run out.
The cooling tube is blocked. Contact the customer service.
The power supply was cut
off during the ice cube
making process.
For the disposal of the device please consider and act
according to the national and local rules and
regulations.
SOLUTION
Make sure that ambient
temperature is below 32 ° C
and pour colder water into the
container.
Contact the customer service.
Pull the plug. Wait for a few
minutes, and then carefully
remove the ice cubes. Switch
the device on and start the ice
cube making process.
phone: +49 (0) 5258 971-0
fax: +49 (0) 5258 971-120