Troubleshooting; Waste Disposal - Bartscher Compact Ice II Mode D'emploi

Masquer les pouces Voir aussi pour Compact Ice II:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

o
Only a qualified technician and using original spare parts and accessories should carry out repairs
and maintenance of the device. Do not attempt to repair the device yourself.

7. Troubleshooting

PROBLEM
The indicator "Add water"
lights up
The indicator "Ice" lights
up.
The indicators "Add water"
and "Ice" lights up.
Ice cubes stick to each
other.
The ice cube making
process is normal but does
not produce any ice cubes.
The power supply was cut
off by mistake during the
ice cube making process.
The control lamp is flashing
on the control panel.

8. Waste disposal

Discarding old devices
At the end of its service life the discarded device has to be disposed in accordance to the national
regulations. It is advisable to contact a company which is specialized in waste disposal, or just contact
the local disposal service in your community.
All manuals and user guides at all-guides.com
POSSIBLE CAUSES
No water.
Too much ice in the ice cube
basket.
Ice scoop is immobilised.
The ice cube making process
is taking too long.
The water temperature in the
container is too low.
The room temperature or the
water temperature in the
container is too high.
Cooling agent has run out.
The cooling tubes are blocked.
The ice cube making process
is automatically stopped.
SOLUTION
Switch off device, fill up with
water and switch on again.
Remove ice from the ice cube
basket.
Check whether ice is blocking
the ice scoop. If not this is not
the case, contact qualified
technician.
Switch off device and switch on
again when ice cubes are
melting.
Select S – small to produce
smaller ice cubes.
Exchange water in the
container. The optimal water
temperature is between 7° -
32° C.
Make sure room temperature is
below 32° C and put colder
water into the container.
A qualified technician should
check it.
A qualified technician should
check it.
Switch off the device and pull
the plug not the cable. Wait for
a few minutes, and then
carefully remove the ice cubes.
Switch on again.
- 21 -

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

A100.063g

Table des Matières