Installation And Connection; Operation - Bartscher Compact Ice II Mode D'emploi

•
See that the cable does not touch any heat sources or sharp edges. Do not let the cable dangle
over the counter edge.
•
Do not use the device in case it does not function properly, has been damaged or dropped.
•
Do not use any accessory or spare parts that have not been recommended by the manufacturer.
These can be dangerous for the user or lead to damages of the device or personal injury, and
further, the warranty expires.
•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep away the cable
from operating range and do not dunk it into water.
•
Do not put any objects into the device. Do not touch any moving or electrical parts inside the
device.
•
Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with that of the
device (see type label).
Connect the device only in case of compliance! Take note of the security advice!

5.2 Installation and connection

•
Unpack the device and discard and remove all of the packing material.
•
Place the device on top of an even and safe surface which supports the weight of the device.
•
Choose a surface where the ice cube maker is not exposed to direct sunlight, or close to a direct
source of heat such as a cooker, oven or radiator.
•
Make sure that there is at least 15 cm distance between the back and the sides of the device and
the wall.
•
Let the cooling agent settle for an hour. Only then plug in the device.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the unit directly to
the wall socket; do not use any extension cords or power strips.
•
If the ice cube maker is kept outside during the winter and then taken inside for use, please let it
warm up to room temperature before plugging it in.
•
Wipe down the outside and the inside of the device with a soft cloth and
the ice cube basket and clean it.
•
Position the device in a way so that the plug is easily accessible.

5.3 Operation

•
Select the required ice cube size by pressing the „Select" button. If the room temperature is
above 16° C, we advise selecting the „S - small" or „M - medium" to avoid the ice cubes sticking
together.
•
Open the lid; remove the ice container and pour water into the container (tank) to just below the
mark.
•
Press the „Power" button on the control panel to start the ice cube making process.
All manuals and user guides at all-guides.com
warm water. Remove
- 19 -