Operation; Setting The Brightness Of The Leds; Setting The Stroboscope Frequency - Oase 50720 Notice D'emploi

6

Operation

6.1

Setting the brightness of the LEDs

Note!
If the spotlight heats up excessively, its luminous intensity is automatically reduced temporarily.
The brightness of the coloured LEDs in a spotlight is controlled via the attendant channel (DMX Channel). The
values 0 to 255 are possible for each channel:
• Value 0: 0% luminous intensity - the LEDs are switched off.
• Value 255: 100% luminous intensity.
• Value 1 ... 254: The LEDs are dimmed.
White content of RGBW capable spotlights:
• RGB operating mode: White content is automatically controlled.
• RGBW operating mode: White content can be manually adjusted.
6.2

Setting the stroboscope frequency

The frequency for the stroboscope effect is set via the strobe channel.
f [Hz]
26
24
22
20
18
16
14
12
10
8
6
4
2
0 15 30 45 60 75 90 105 120
Caption Description
f [Hz] Stroboscope frequency in Hz
DMX value Stroboscope value
0 ... 3
4
5
6
7 ... 255
Note!
If the spotlights are intended to flash synchronously, the stroboscope channels have to be set simultaneously.
Continuous light, no stroboscope effect
Fast random flashing of the spotlights, asynchronous transmission of the stroboscope frequency to the spotlights
Normal random flashing of the spotlights, asynchronous transmission of the stroboscope frequency to the spotlights
Slow random flashing of the spotlights, asynchronous transmission of the stroboscope frequency to the spotlights
For the stroboscope frequency see diagram.
135 150 165 180 195 210 225
- GB -
240 255 DMX value
UWR0013
23