AEG SKS61840S1 Notice D'utilisation page 34

34 www.aeg.com
~50 mm
~50 mm
21 mm
Ha
Hc
8 mm
Hb
Install the part (Ha) on the inner side of
the kitchen furniture.
o
90
o
90
o
90
Push the part (Hc) on the part (Ha).
Open the appliance door and the kitchen
furniture door at an angle of 90°.
Insert the small square (Hb) into guide
(Ha).
Put together the appliance door and the
furniture door and mark the holes.
Remove the small squares and drill holes
with ø 2 mm at 8 mm from the outer edge
of the door.
Place the small square on the guide again
Ha
and fix it with the screws supplied.