INSTALLATION REQUIREMENTS
LOCATION REQUIREMENTS
NOTE: If the washer/dryer and pedestal assembly are located in
a garage, 3" (76 mm) must be added under the pedestal so that
the washer/dryer is 18" (457 mm) above the garage floor.
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools Needed:
Utility knife
Level
Pliers or slip-joint pliers
2
1/4" hex-head ratchet
or open-end wrench
9/16" open-end wrench
Bucket
1/4" nut driver
Additional Items Needed:
Towel
Parts Supplied:
Four #12 x 5/8" hex-head
sheet metal screws
5/16" hex-head ratchet
or nut driver
Sponge
Drawer divider