Installing The Pedestal - Whirlpool WFP2715HW0 Instructions D'installation

Uninstalling your electric dryer
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
WARNING
Excessive Weight Hazard
Use two or more people to move and uninstall dryer.
Failure to do so can result in back or other injury.
1. Unplug the power supply cord or disconnect wiring if dryer is
direct wired.
2. Pull the dryer away from the wall enough to loosen the vent
clamp. Loosen the clamp and gently remove the exhaust vent
from the dryer exhaust outlet.
3. Pull the dryer away from the wall so that you will have enough
space for the installation.
Uninstalling your gas dryer
WARNING
Excessive Weight Hazard
Use two or more people to move and uninstall dryer.
Failure to do so can result in back or other injury.
1. Unplug the power supply cord.
2. Turn off the gas supply.
3. Pull the dryer away from the wall enough to loosen the vent
clamp. Loosen the clamp and gently remove the exhaust vent
from the dryer exhaust outlet.
4. Disconnect the flexible gas supply line from the dryer. Put a
piece of tape over the open ends of the gas line connection
fittings.
5. Pull the dryer away from the wall so that you will have enough
space for the installation.
Installation of new washer/dryer
WARNING
Excessive Weight Hazard
Use two or more people to move and install
washer/dryer.
Failure to do so can result in back or other injury.
1. Unpack the washer/dryer and move close to the intended
installation location.

INSTALLING THE PEDESTAL

Installing the pedestal on the washer
Confirm transport bolts are in place
Locate the transport bolts on rear of washer. Transport bolts
must remain in washer before pedestal can be installed. For
more information on transport bolts see, "Remove Transport
System" in washer Use and Care Guide.
5