Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.
Secure pedestal to washer
Position the pedestal toward the front of the washer and
install the two remaining hex-head sheet metal screws.
Do not tighten completely. Now proceed to "Complete
the pedestal installation".
Installing the pedestal on the dryer
1.
Place dryer on its side
To avoid floor damage and ease installation and handling,
unfold the empty pedestal box flat and place it next to the dryer.
Position the drawer divider so that it will be near the top of the
dryer, as shown. Gently tip the dryer on its side so the dryer is
resting on the drawer divider.
2.
Prepare the dryer
Dryer bottom
Partially install two of the #12 x 5/8" hex-head sheet metal
screws in the indicated holes. Leave a space of about
3/8" (10 mm) between the screw head and the bottom of the
dryer.
NOTE: If your dryer has leveling feet installed, remove them.
Do not install the feet that came with the new dryer.
Drawer divider
Pedestal box
3.
Attach pedestal to dryer
Move the pedestal against the dryer bottom. The front of
the pedestal cabinet should align with the dryer cabinet
as shown below.
Slide the pedestal's keyhole slots over the lower two partially
installed screws.
Pedestal
View from above
4.
Secure pedestal to dryer
Position the pedestal toward the front of the dryer and install
the two remaining hex-head sheet metal screws. Do not tighten
completely. Now proceed to "Complete the pedestal installation".
Dryer
Front
7
Publicité
Table des Matières
